- Free shipping, carbon neutral, from $99 purchase
- Financing up to 36 months with Affirm or Sezzle
- Environmentally friendly packaging
- Low stock - 1 item left
This superb walnut badger made by Gaston creations, a Sherbrooke cabinetist craftsman, offers not only a very chic and masculine look, but also an unparalleled shaving experience!
For respect for animals, we have privileged the highest quality of synthetic hair offered on the market. In addition to being soft for the skin, this hair is odorless, it remains well in place, and it gives a creamy and generous shaving mousse.
Video (31 seconds) demonstrating how to mount the foam soap with the badger.
Optimal use
- Rinse the badger underwater;
- Rub the hair on the pure beard soap OM for about ten seconds;
- Rinse your face with hot water;
- Rub the badger again on the soap so that it creates an even more unctuous foam. The more you rub, the more the foam will mount;
- Apply the foam onto a part of your face by sliding the side badger next to it;
- Shave;
- Repeat, if necessary, the steps 5-6-7 for the entire face.
- Once finished, rinse the hair under hot water and ideally, remove the badger the hair down.
The dyeing, painting and varnish used are the same as those used for the manufacture of bar holders and housings.
Dimensions
Total height: 14 cmChannel width: 3.5 cm
Regional and National | Canada
- Standard
| 3-9 days | $11.99
(free from $99 purchase) - Accelerated | 3-7 days | $15.99
- Priority | 1-3 days | $29.99
United States | USA
- USA Standard | 6-14 days | $19.99 USD (free from $99 USD purchase)
- Accelerated USA | 4-8 days | 39.99S USD
France
- StandardFRANCE | 10-20 days | 19.99$ EUR (free from 99$ EUR purchase)
Rest of the World | International
- Canada Post Tracked Packet International | 7-15 Days | Prices calculated upon payment
- Canada Post Xpresspost International | 6-12 Days | Prices calculated upon payment
Rings
Option 1
1- Take a paper tape
2- Wrap the tape around your finger, loosely, and mark the tape with a pencil where it overlaps on itself.
3- Measure the size of the ribbon up to your mark (in mm)
4- Refer to the correspondence table here
Option 2
1- You get a plastic ring sizer here
Necklaces & chains
